Cant go to Full screen

Paiste · 01/28/2006 15:38:50

When I try to enter full screen my monitor goes blank. After a while it goes back to the windowed mode. This started happening when i tweaked up the settings from the Catalyst Control Center. I restored the settings back to factory settings and it's still the same. Help? :smileysad:

Message Edited by Paiste on 01-28-200603:38 PM

Paiste

I reinstalled my graphics drivers and that did the trick :smileyhappy:

TSRCoryS

Thanks for the update. It's odd that a system restore to an earlier point did not put the graphics drivers back to that state for you. What version of the drivers are you using, on what graphics card, in case others run into a similar problem?

[edit] It's not my spelling that's bad, it's my letter spacing[/edit]

Message Edited by TSRCoryS on 01-31-2006 05:25 AM
Message edited by TSRCoryS on 01/31/2006 05:25:33.

**phi**

The problem is caused by a screen refesh speed that the monitor can't handle.

Resetting the driver customizations doesn't change the monitor settings back.

I take it you restored the driver settings, not a windows system-state restore.

reinstalling the drivers would have done an auto-detect that would automatically set themonitor to it's optimal safe defaults (typically 60Hz refresh speed)